News

DEANS® Tech Bench - Ultra Plug® vs. T-Plug Clones - Parallel Amp Test

DEANS® Tech Bench - Ultra Plug® vs. T-Plug Clon...

Here at W.S. Deans, we are proud to offer high quality connectors.  The most critical feature of a connectors is its ability to pass current by minimizing resistance.  In the...

DEANS® Tech Bench - Ultra Plug® vs. T-Plug Clon...

Here at W.S. Deans, we are proud to offer high quality connectors.  The most critical feature of a connectors is its ability to pass current by minimizing resistance.  In the...

Deans® Tech Bench

DEANS® Tech Bench - Can the Deans® Ultra Plug® ...

We get asked all the time, "How much can it handle?"  Well it will always depend on how the system is built and how long the current is applied.  That being...

DEANS® Tech Bench - Can the Deans® Ultra Plug® ...

We get asked all the time, "How much can it handle?"  Well it will always depend on how the system is built and how long the current is applied.  That being...

DEANS® Tech Bench - Heat Matters

DEANS® Tech Bench - Heat matters in the system

Temperature can be both good and bad for the performance of your vehicle.  In the news, we have heard about the drawbacks of the of electric vehicles (EVs) in cold...

DEANS® Tech Bench - Heat matters in the system

Temperature can be both good and bad for the performance of your vehicle.  In the news, we have heard about the drawbacks of the of electric vehicles (EVs) in cold...

DEANS® Engineering - Step 5 Can we make it more professional

DEANS® Engineering - Step 5 Can we make it more...

Last time, we made a version that was lasercut rather than 3D printed.  3D printing is great for prototyping, but can take quite a while to make.  Lasering or injection...

DEANS® Engineering - Step 5 Can we make it more...

Last time, we made a version that was lasercut rather than 3D printed.  3D printing is great for prototyping, but can take quite a while to make.  Lasering or injection...

DEANS® Engineering - Step 4 It feels too small

DEANS® Engineering - Step 4 It feels too small

In the previous post, we 3D printed a small connector holder.  It just did not feel robust enough.  Yes, I said "feel".  In product design there are elements of fit,...

DEANS® Engineering - Step 4 It feels too small

In the previous post, we 3D printed a small connector holder.  It just did not feel robust enough.  Yes, I said "feel".  In product design there are elements of fit,...

DEANS® Engineering - Step 4 Can we make it simpler

DEANS® Engineering - Step 4 Can we make it simpler

In the previous post, we looked at the several feaures that looked important to the basics of the design.  We wanted to hold the part in the angles that were...

DEANS® Engineering - Step 4 Can we make it simpler

In the previous post, we looked at the several feaures that looked important to the basics of the design.  We wanted to hold the part in the angles that were...